Telit Wireless Solutions LE910C series - AT#GPPPCFG - PPP-GPRS Parameters Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 812 of 1904 2022-03-04
Not Subject to NDA
3.9.18. AT#GPPPCFG - PPP-GPRS Parameters Configuration
This command permits to set parameters for a PPP-GPRS connection
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#GPPPCFG=<hostIPaddress>[,<unused_A>][,<unused_B>]]
Set command sets one parameter for a dial-up connection
Parameters:
Name
Type
Default
Description
<hostIPaddress>
string
-
Host IP address that is assigned to
the PPP server side (the host
application); String type, it can be
any valid IP address in the format:
"XXX.XXX.XXX.XXX"
<unused_A>
integer
-
unused parameter
<unused_B>
integer
-
unused parameter
if <hostIPaddress>="000.000.000.000" (factory default), host
address is not included in the IPCP Conf Req and the host address
choice is left to the peer
AT#GPPPCFG?
Read command reports the current PPP-GPRS connection parameters in
the format:
#GPPPCFG: <hostIPaddress>,<unused_A>,<unused_B>