Telit Wireless Solutions LE910C series - GNSS General Management; AT$GNSSSLCT - GNSS System Select

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1719 of 1904 2022-03-04
Not Subject to NDA
3.28.3. GNSS General Management
3.28.3.1. AT$GNSSSLCT - GNSS System Select
This command configures to set GNSS System Select.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT$GNSSSLCT=<gnss_conf>
Set command configures the GNSS receiver to look for the requested
GNSS systems.
Parameter:
Name
Type
Default
Description
<gnss_conf>
integer
0
enumeration of GNSS configurations
Values:
0
:
GNSS_ALL (gps+glonass+galileo+beidou)
1
:
BDS_ONLY (gps+beidou)
2
:
BDS_GAL (gps+galileo+beidou)
3
:
GLO_BDS (gps+glonass+beidou)
4
:
GAL_ONLY (gps + galileo)
5
:
GLO_ONLY (gps + glonass)
6
:
GLO_GAL (gps + glonass + galileo)
7
:
GPS_ONLY (gps alone)
New <gnss_conf> takes effect only after power up or reboot.