Telit Wireless Solutions LE910C series - AT+CGDATA - Enter Data State

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 838 of 1904 2022-03-04
Not Subject to NDA
3.9.26. AT+CGDATA - Enter Data State
This command causes the device to establish a connection with the network. Commands
following +CGDATA command in the AT command line shall not be processed by the
device.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CGDATA=[<L2P>,[<cid>[,<cid>[,….]]]]]
Set command causes to perform whatever actions are necessary to
establish a communication with the network using one or more GPRS PDP
types.
Parameters:
Name
Type
Default
Description
<L2P>
string
-
String parameter that indicates the layer 2
protocol to be used
"PPP" - PPP Point-to-point protocol
<cid>
integer
-
Numeric parameter which specifies a
particular PDP context definition (see
+CGDCONT command)
If parameter <L2P> is omitted, the layer 2 protocol is unspecified
AT+CGDATA=?
Test command reports information on the supported layer 2 protocols.