Telit Wireless Solutions LE910C series - AT#BPNPPVER - BLE Product Version ID

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1862 of 1904 2022-03-04
Not Subject to NDA
3.35.15. AT#BPNPPVER - BLE Product Version ID
This command is used to set the BLE product version ID.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BPNPPVER=<Product Version>
Set command is used to set the product version provided in the device
information service (DIS). To activate a new PNPPVER value, it is
necessary to store the settings and perform a reset.
Parameter:
Name
Type
Default
Description
<Product
Version>
hex
N/A
It specifies the version of the product to
be set which is a 16-bit hex value. For
example, 0x0100 for firmware version
1.00.
Value:
0x0÷0xFFFF
:
The supported parameter value range.
This value can be saved into profile
through AT#W command.
AT#BPNPPVER?
Read command is used to get the status of the product version in the
device information service:
#BPNPPVER: <PnP Product Version>
AT#BPNPPVER?
#BPNPPVER: 700
OK