Telit Wireless Solutions LE910C series - AT#SKTCT - Socket TCP Connection Time-Out

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1296 of 1904 2022-03-04
Not Subject to NDA
3.17.33. AT#SKTCT - Socket TCP Connection Time-Out
This command sets the TCP connection timeout to wait the first CONNECT message
sent by the TCP peer.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#SKTCT=[<tout>]
Set command sets the TCP connection time-out for the first CONNECT
answer from the TCP peer to be received.
Parameter:
Name
Type
Default
Description
<tout>
integer
600
TCP first CONNECT answer time-out in
100ms units
Value:
10÷1200
:
hundreds of ms
this time-out applies only to the time that the TCP stack waits for
the CONNECT answer to its connection request.
The time for activate the GPRS and resolving the name with the
DNS query (if the peer was specified by name and not by address)
is not counted in this time-out.
AT#SKTCT?
Read command reports the current TCP connection time-out.
AT#SKTCT=?