Telit Wireless Solutions LE910C series - AT#ECMD - ECM Shutdown

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1201 of 1904 2022-03-04
Not Subject to NDA
3.16.1.3. AT#ECMD - ECM Shutdown
This command is used to shutdown an Ethernet Control Model (ECM) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#ECMD=<Did>
Set command to shutdown an Ethernet Control Model (ECM) session.
Parameter:
Name
Type
Default
Description
<Did>
integer
N/A
Device id, currently limited to 0 (only one
device)
Value:
0
:
Device id (currently limited to only one device)
NOTE: this command also deactivates the context.
NOTE: If ECM backhaul is not connected yet, Returns OK
NOTE: LE910C1-EUX, to make active the command the module
must be rebooted.
AT#ECMD?
Read command returns the session state in the following format:
#ECM: <Did>,<State>
OK
Additional info: