Telit Wireless Solutions LE910C series - AT#BPNPPID - BLE Product ID

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1860 of 1904 2022-03-04
Not Subject to NDA
3.35.14. AT#BPNPPID - BLE Product ID
This command is used to set BLE product ID.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BPNPPID=<Product ID>
Set command is used to set product ID provided in the device information
service (DIS). To activate a new PNPPID value, it is necessary to store the
settings and perform a reset.
Parameter:
Name
Type
Default
Description
<Product
ID>
hex
N/A
It specifies the value of the product ID
to be set which is a 16-bit hex value.
Value:
0x0÷0xFFFF
:
The supported parameter value range.
This value can be saved into profile
through AT#W command.
AT#BPNPPID?
Read command is used to get the status of the product ID in the device
information service:
#BPNPPID: <PnP Product ID>
Where,
<PnP Product ID> - Specifies the Product ID. For example:
AT#BPNPPID?
#BPNPPID: B01A
OK