Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 739 of 1904 2022-03-04
Not Subject to NDA
3.8.17. AT#WLANBD - Store and erase custom bin file
This command is used to add or change the WLAN board data firmware file or otp file.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#WLANBD=<index>[,<size>]
Set command allows to add or change the WLAN board data firmware file
or otp file.
Parameters:
Name
Type
Default
Description
<index>
integer
N/A
This parameter specifies the type of bin file
for upload.
Values:
0
:
bdwlan.bin (WLAN board data firmware)
1
:
otp.bin (otp)
<size>
integer
-
The parameter is optional parameter to
specify the size of wlan board data firmware
file or otp bin. If this parameter not
specified, the data transfer will be ended
when the '+++' has been input.
If the size parameter is zero and there are
added bin file matched to the <index>, it will
be cleared for set to default.
6. The new bin will be applied after next wlan enable.
7. The new bin will be stored in the file system and will not be
cleared even after a reboot. The new bin will be used as
default if it's exist.
8. The new bin will be set to default (cleared) after the
LE910Cx is flashed with TFI or XFP.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English