Telit Wireless Solutions LE910C series - ATX - Extended Result Codes

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 315 of 1904 2022-03-04
Not Subject to NDA
3.2.4.18. ATX - Extended Result Codes
This command allows to select the subset of result code messages.
ITU-T Recommendation V.25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
ATX[<n>]
Set command selects the subset of result code messages the modem
uses to reply to the DTE upon AT commands execution.
Parameter:
Name
Type
Default
Description
<n>
integer
1
configuration value
Values:
0
:
when entering in dial mode a CONNECT result code is
relayed; see Additional info.
1÷4
:
when entering in dial mode a CONNECT <text> result
code is relayed, see Additional info.
Additional info:
<n>=0
OK, CONNECT, RING, NO CARRIER, ERROR, NO ANSWER result
codes are enabled. Dial tone and busy detection (NO DIALTONE
and BUSY result codes) are disabled.
<n>=1÷4
all the remaining result codes are enabled.