Telit Wireless Solutions LE910C series - AT#DWSENDR - Send Raw Data to Iot Portal

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1574 of 1904 2022-03-04
Not Subject to NDA
3.25.3. AT#DWSENDR - Send Raw Data to IoT Portal
The command is related to sending data to the IoT Portal
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#DWSENDR=<dataLen>
Execution command permits to send raw data to the M2M Service.
Content must be valid JSON.
Parameter:
Name
Type
Default
Description
<dataLen>
integer
N/A
number of bytes to be sent
Value:
1÷1500
:
range of the number of bytes to be sent
Additional info:
<dataLen> - number of bytes to be sent
The module responds to the command with the prompt
<greater_than><space> and waits for the data to send.
When <dataLen> bytes have been sent, operation is automatically
completed.
If data are successfully sent, then the response is OK.
If data sending fails for some reason, an error code is reported.