Telit Wireless Solutions LE910C series - Page 1575

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1575 of 1904 2022-03-04
Not Subject to NDA
the response to the AT#DWSENDR command reports the
<msgId> value that identifies the sending.
There is also a limit of 20 messages on the receive queue. If the
queue is full, the consequent send will still succeed but the
response for that particular request will be dropped until an item is
removed from this queue (See command AT#DWRCV and
AT#DWRCVR).
it's possible to use AT#DWSENDR only if the connection has been
opened with AT#DWCONN .
AT#DWSENDR=?
Test command reports the supported range of values for
<dataLen> parameter.