Telit Wireless Solutions LE910C series - AT#WLANCONFIG - Add or Change the Hostapd.conf

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 727 of 1904 2022-03-04
Not Subject to NDA
3.8.10. AT#WLANCONFIG - Add or change the hostapd.conf
This command is used to add hostapd.conf file.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#WLANCONFIG=<size>
Set command allows to add or change the hostapd.conf.
Hostapd configuration file controls many options with regards to AP mode
only, in which not all are supported by the current WIFI chip.
Parameter:
Name
Type
Default
Description
<size>
integer
-
File size
AT#WLANCONFIG=?
Test command returns OK result code.