Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 270 of 1904 2022-03-04
Not Subject to NDA
3.2.3.7. ATS7 - Connection Completion Time-Out
This set command specifies the amount of time that the DCE shall allow between either
answering a call (automatically or by the ATA command) or completion of signaling of
call addressing information to network (dialing), and establishment of a connection with
the remote DCE. If no connection is established during this time, the DCE disconnects
from the line and returns a result code indicating the cause of the disconnection.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATS7=<tout>
Set command sets the amount of time, in seconds, that the device shall
allow between either answering a call(automatically or by A command) or
completion of signaling of call addressing information to network (dialing),
and establishment of a connection with the remote device.
Parameter:
Name
Type
Default
Description
<tout>
integer
0
defines time interval expressed in seconds
Values:
0
:
disabled
1÷255
:
available range
At LE910C1-AP (for JAPAN), a max value is 100.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English