Telit Wireless Solutions LE910C series - AT#DNS - Manual DNS Selection

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1325 of 1904 2022-03-04
Not Subject to NDA
3.17.44. AT#DNS - Manual DNS Selection
This command manually set primary and secondary DNS servers.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#DNS=<cid>,<primary>,<secondary>
Set command allows to manually set primary and secondary DNS servers for a
PDP context defined by +CGDCONT.
Parameters:
Name
Type
Defa
ult
Description
<cid>
intege
r
N/A
numeric parameter which specifies a particular
PDP context definition
The value of max is returned by the Test command.
Value:
1÷max
:
specifies a particular PDP context definition
<primary
>
string
-
Ipv4- manual primary DNS server, string type, in the
format "xxx.xxx.xxx.xxx" used for the specified cid;
we're using this value instead of the primary DNS
server come from the network (default is "0.0.0.0")
Ipv6- manual primary DNS server, string type, in the
format
"xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.xxx.x
xx.xxx.xxx" used for the specified cid; we're using
this value instead of the primary DNS server come
from the network (default is
"0.0.0.0.0.0.0.0.0.0.0.0.0.0.0.0".
Ipv6 can also be in HEX format:
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx"