Telit Wireless Solutions LE910C series - SIM Toolkit; AT#STIA - SIM;USIM Toolkit Interface Action

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 931 of 1904 2022-03-04
Not Subject to NDA
SIM Toolkit
3.11.1. AT#STIA - SIM/USIM Toolkit Interface Action
The SIM/USIM Application Toolkit (SAT/USAT) provides an interface to the applications
existing in the SIM/USIM device. The module must support the mechanisms required by
the SIM/USIM applications.
[1] 3GPP TS 23.038
[2] 3GPP TS 31.111
[3] Telit SIM/USIM Application Toolkit Application Note
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT#STIA=[<mode>[,<timeout>]]
Set command is used to enable/disable the SIM/USIM Application Toolkit
(SAT/USAT). In addition, the command can enable the URCs sending.
Parameters:
Name
Type
Default
Description
<mode>
integer
1
enables/disables SAT/USAT.
In addition, <mode> parameter enables
the:
- #STN URCs notifying the user that the
SIM/USIM application has issued a
proactive command. Some proactive
commands require a user response.
- #STN URCs that are the SIM/USIM
device responses concerning actions
initiated by the user, refer to Additional
info section.