Telit Wireless Solutions LE910C series - AT$GPSP - GNSS Positioning Session Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1716 of 1904 2022-03-04
Not Subject to NDA
3.28.2.5. AT$GPSP - GNSS Positioning Session Control
This command controls the GNSS positioning session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT$GPSP=<status>
The set command allows to control the GNSS positioning session.
Parameter:
Name
Type
Default
Description
<status>
integer
0
GNSS positioning session status
Values:
0
:
Stop GNSS positioning session
1
:
Start GNSS positioning session
This command only controls the started GNSS positioning session
from $GPSP and $GPSSLSR. The GNSS positioning sessions of
other Service (IMS, MDT or UIM) cannot be controlled.
The Start GNSS positioning session clears GNSS memory and then
powers up the GNSS receiver if it powers down. The GNSS data
cleaning is performed on the base of the current value of the
<reset_type> parameter (see $GPSR).
The GNSS operation mode of Start GNSS positioning session is
performed on the base of the current values of $GPSSLSR
configuration (see $GPSSLSR).
The $GPSP and $GPSSLSR cannot be used at same time.