Telit Wireless Solutions LE910C series - Page 1717

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1717 of 1904 2022-03-04
Not Subject to NDA
AT$GPSP?
The read command reports the current value of the <status> parameter, in
the format:
$GPSP: <status>
Where:
<status> - GNSS positioning session status
0 - GNSS positioning session is not working
1 - GNSS positioning session is working
AT$GPSP=?
The test command reports the supported values range for parameter
<status>.
$GPSP: (0,1)
The current <status> value is stored through $GPSSAV command.
Start GNSS positioning session.
AT$GPSP=1
OK
Stop GNSS positioning session.
AT$GPSP=0
OK