Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1153 of 1904 2022-03-04
Not Subject to NDA
3.15.25. AT#GSMAD - GSM Antenna Detection
Set the behavior of the antenna detection algorithm. To use this command, the module
must be provided by a specific circuitry, refer to document [1].
[1] Telit Antenna Detection Application Note, 80000NT10002A
[2] Telit Hardware Design Guide of the used module
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#GSMAD=<mod>[,<urcmode>[,<interval>[,<detGPIO>[,<repGPIO>[,<antenna>[,<
adc>]]]]]]
Set command sets the behavior of antenna detection algorithm. Refer to
document [2] to have information on GPIO pins.
Parameters:
Name
Type
Default
Description
<mod>
integer
0
selects the antenna detection mode.
Refer to Additional info section.
Values:
0
:
antenna detection not active; format is
AT#GSMAD=0[,<adc>]
1
:
periodic activation of the antenna detection
2
:
instantaneous activation of the antenna detection
3
:
as <mod>=2, but the command does not return the
control until the detection algorithm ended
<urcmode>
integer
0
selects the URC presentation mode. It
has meaning and can be set only if
<mod>=1.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English