Telit Wireless Solutions LE910C series - Page 1154

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1154 of 1904 2022-03-04
Not Subject to NDA
Values:
0
:
disable the antenna detection URC
1
:
enable the antenna detection URC
<interval>
integer
120
interval between two consecutive
antenna detection algorithm runs. It is
expressed in seconds, and has meaning
only if <mod>=1.
Value:
1÷3600
:
seconds
<detGPIO>
integer
0
defines which GPIO pin is used by the
antenna detection algorithm as input.
The chosen GPIO must be configured in
alternate function, refer to #GPIO
command.
Values:
0
:
no GPIO pin is used
1÷max
:
max value depends on the module hardware
<repGPIO>
integer
0
defines which GPIO pin is used by the
antenna detection algorithm (as output)
to report antenna status. It has meaning
only if <mod>=1.
The chosen GPIO must be configured in
alternate function, refer to #GPIO
command.
Value 0 means that no report is made
using GPIO (default 0).
Values:
0
:
no GPIO is used
1÷max
:
max value depends on the module hardware