Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 515 of 1904 2022-03-04
Not Subject to NDA
3.4.51. AT+CDIP - Called line identification presentation
This command enables/disables the presentation of the CLI at the TE.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CDIP=[<n>]
Set command enables/disables the presentation of the CLI (called line
identifications) at the TE.
This command related to a network service that provides "multiple called
numbers (called line identifications) service" to an MT. This command
enables a called subscriber to get the called line identification of the
called party when receiving a mobile terminated call.
When the presentation of the called line identification at the TE is enabled,
the below URC is returned after every RING (or +CRING: <type>; refer
subclause "Cellular result codes +CRC") result code sent from TA to TE. It
is manufacturer specific if this response used when normal voice call
answered.
+CDIP:<number>,<type>[,<subaddr>,<satype>]
Parameter:
Name
Type
Default
Description
<n>
string
N/A
parameter sets/shows the result code
presentation status to the TE
Values:
0
:
disable
1
:
enable
Unsolicited fields:

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English