Telit Wireless Solutions LE910C series - Tones Configuration; AT#STM - Signaling Tones Mode

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 992 of 1904 2022-03-04
Not Subject to NDA
3.12.2. Tones configuration
3.12.2.1. AT#STM - Signaling Tones Mode
This command enables/disables the signaling tones output on the audio path
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Common
profile
No
-
2
AT#STM=[<mode>]
Set command enables/disables the signalling tones output on the audio
path selected with #SRP command (LE910x supported by fix SRP only).
Parameter:
Name
Type
Default
Description
<mode>
integer
1
signaling tones status
Values:
0
:
signaling tones disabled
1
:
signaling tones enabled
2
:
all tones disabled
AT#STM=0 has the same effect as AT+CALM=2.
AT#STM=1 has the same effect as AT+CALM=0.
AT#STM?
Read command reports whether the current signaling tones status is
enabled or not, in the format: