Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 932 of 1904 2022-03-04
Not Subject to NDA
If <mode>=2, the URC format depends on
the <cmdType> as described in the
Additional info sections. For <cmdType>,
and all other URC parameters refer to
#STGI command. The <mode> parameter
values are listed below.
Values:
0
:
disable SAT/USAT
1
:
enable SAT/USAT without #STN URC
2
:
enable SAT/USAT and extended #STN URC
3
:
enable SAT/USAT and reduced #STN URC
17
:
enable SAT/USAT without #STN URC and the
alphabet used
18
:
enable SAT/USAT, extended #STN URC, and the
alphabet used
19
:
enable SAT/USAT, reduced #STN URC, and the
alphabet used
33
:
enable SAT/USAT without #STN URC and the UCS2
alphabet used
34
:
enable SAT/USAT, extended #STN URC, and the
UCS2 alphabet used
35
:
enable SAT/USAT, reduced #STN URC, and the
UCS2 alphabet used
<timeout>
integer
1
When an ongoing proactive command,
requiring a user response, is not
answered before <timeout> minutes, it is
automatically aborted. In this case, the
terminal response from the module is
either "ME currently unable to process
command" or, if applicable, "No response
from user". In addition, the following URC
is sent on the AT interface. For parameter

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English