EasyManuals Logo

Telit Wireless Solutions LE910C series At Commands Reference Guide

Telit Wireless Solutions LE910C series
1904 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #837 background imageLoading...
Page #837 background image
LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 837 of 1904 2022-03-04
Not Subject to NDA
AT+CGTFT: <cid>, <packet filter identifier>, <evaluation precedence index>, <source
address and subnet mask>, <protocol number (ipv4) / next header (ipv6)>,
<destination port range>, <source port range>, <ipsec security parameter index
(spi)>, <type of service (tos) (ipv4) and mask /traffic class (ipv6) and mask>, <flow
label (ipv6)> [<CR><LF>+CGTFT: <cid>, <packet filter identifier>, <evaluation
precedence index>, <source address and subnet mask>, <protocol number (ipv4) /
next header (ipv6)>, <destination port range>, <source port range>, <ipsec security
parameter index (spi)>, <type of service (tos) (ipv4) and mask / traffic class (ipv6)
and mask>, <flow label (ipv6)> [...]]
AT+CGTFT=?
The test command returns values supported as a compound value. If the MT
supports several PDP types, the parameter value ranges for each PDP type
returned on a separate line. TFTs shall be used for PDP-type IP and PPP only. For
PDP-type PPP a TFT is applicable only when IP traffic is carried over PPP. If PPP
carries header-compressed IP packets, then a TFT cannot be use.
AT+CGTFT: <PDP_type>, (list of supported <packet filter identifier>s), (list of
supported <evaluation precedence index>s), (list of supported <source address and
subnet mask>s), (list of supported <protocol number (ipv4) / next header (ipv6)>s),
(list of supported <destination port range>s), (list of supported <source port
range>s), (list of supported <ipsec security parameter index (spi)>s), (list of
supported <type of service (tos) (ipv4) and mask / traffic class(ipv6) and mask>s),
(list of supported <flow label (ipv6)>s) [<CR><LF>+CGTFT: <PDP_type>, (list of
supported <packet filter identifier>s), (list of supported <evaluation precedence
index>s), (list of supported <source address and subnet mask>s),(list of supported
<protocol number (ipv4) / next header (ipv6)>s), (list of supported <destination port
range>s), (list of supported <source port range>s), (list of supported <ipsec security
parameter index (spi)>s),(list of supported <type of service (tos) (ipv4) and mask /
traffic class (ipv6) and mask>s), (list of supported <flow label (ipv6)>s) [...]]
The possible combinations listed on 3GPP TS 23.060 [47].

Table of Contents

Other manuals for Telit Wireless Solutions LE910C series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910C series and is the answer not in the manual?

Telit Wireless Solutions LE910C series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910C series
CategoryWireless modules
LanguageEnglish

Related product manuals