LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1089 of 1904 2022-03-04
The execution command #FASTSHDN<CR><LF> forces the module
to execute immediately fast power down regardless to the GPIO
status or enabled status.
All configured values stored on module and applied after next
power cycle.
However, LE910C1-EUX/SAX/SVX and LE910Cx-WWX can be
applied immediately.
The stored configuration is maintained when after firmware
switching.
It has highest priority than other functions when fast power down
enabled and GPIO is used as fast power down event monitoring.
Customer should not use GPIO for other function.
Execution command response can be omitted to reduce time
taking on power down.
Should do not use GPIO8 as fast power down pin on mPCIe type.
AT#FASTSHDN?
Read command returns the saved value in the format:
#FASTSHDN: <enable>
,<pin>
AT#FASTSHDN=?
Test command reports the range for the parameters <enable> and <pin>.
To Next Page
Loading...
Need help?
General
