Telit Wireless Solutions LE910C series - Page 1195

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1195 of 1904 2022-03-04
Not Subject to NDA
If a PDP context is already established , return OK
If user configuration is not in proper format, return ERROR
- ex) ip: 192.168.225.2 , nm: 255.255.255.0 gw: 1.1.111.1
If user try to set different network configuration comparing to
current one using AT#ECMC first. Then upon executing #ECM
command, the UART console will be disconnected as USB driver
will be reloaded to make host device broadcast DHCP.
For LE910C1-EUX, to enable the ECM session configuration the
module must be rebooted.
AT#ECM?
Read command returns the session state in the following format:
# ECM: <Did>,<State>
OK
Additional info:
Here are the parameters meaning returned by the read command
and not described in the previous sections.
Name
Type
Default
Description
<Did>
integer
-
Device id ( only 0 is valid)
<State>
integer
0
ECM session status
Values:
0
:
disabled
1
:
enabled