Telit Wireless Solutions LE910C series - Page 1216

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1216 of 1904 2022-03-04
Not Subject to NDA
<delay>
integer
N/A
specifies the delay in seconds
between an attempt and the next
one
Value:
180÷3600
:
supported range
<urcmode>
integer
0
URC presentation mode.
Values:
0
:
disable unsolicited result code
1
:
enable unsolicited result code, after an automatic
activation/reactivation, of the local IP address
obtained from the network. It has meaning only if
<auto>=1
Additional info:
The unsolicited message is in the format:
If IP or IPV6 PDP context:
#SGACT: <ip_address>
For DUAL STACK IPV4V6 PDP context:
#SGACT: [<ipAddrV4>],[<ipAddrV6>]
Reporting the local IP address obtained from the network.
the URC presentation mode <urcmode> is related to the current AT
instance only.
Last <urcmode> setting is saved for every instance as extended
profile parameter, thus it is possible to restore it even if the
multiplexer control channel is released and set up, back and forth.
<retry> and <delay> setting is global parameter saved in NVM