Telit Wireless Solutions LE910C series - Page 1217

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1217 of 1904 2022-03-04
Not Subject to NDA
if the automatic activation is enabled on a context, then it is not
allowed to modify by the command AT#SCFG the association
between the context itself and the socket connection identifier; all
the other parameters of command AT#SCFG are modifiable while
the socket is not connected
AT#SGACTCFG?
Read command reports the state of all the five contexts, in the format:
#SGACTCFG: <cid1>,<retry1>,<delay1>, < urcmode >CR><LF>
...
#SGACTCFG: <cid max>,<retry5>,<delay5>,< urcmode >
Additional info:
parameters meaning.
Name
Type
Default
Description
<cidn>
integer
-
PDP context identifier
<retryn>
integer
-
specifies the maximum number of
context activation attempts in
case of activation failure
<delayn>
integer
-
specifies the delay in seconds
between an attempt and the next
one
<urcmode>
integer
-
URC presentation mode
AT#SGACTCFG=?
Test command reports supported range of values for parameters <cid>
>,<retry>,<delay>and < urcmode >.