Telit Wireless Solutions LE910C series - Page 98

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 98 of 1904 2022-03-04
Not Subject to NDA
After power off/on in LE910Cx the value returen to
"0".
+CR: <serv>
Values:
ASYNC
:
asynchronous transparent
SYNC
:
synchronous transparent
REL ASYNC
:
asynchronous non-transparent
REL SYNC
:
synchronous non-transparent
This command replaces V.25ter [14] command Modulation
Reporting Control (+MR), which is not appropriate for use with a
UMTS terminal.
AT+CR?
Read command returns whether or not intermediate result code +CR is
enabled, in the format:
+CR: <mode>
AT+CR=?
Test command returns the supported range of values of parameter
<mode>.