Telit Wireless Solutions LE910C series - Page 1136

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1136 of 1904 2022-03-04
Not Subject to NDA
Values:
0
:
Low state
1
:
High state
If <pin> is set to <mode>=2 by #V24CFG, the <state> is not actual
state because pin is controlled by kernel GPIO driver.
If <pin>=1, 5, 6 or 7 is set to <mode>=2 or 1 by #V24CFG, the state
of the unset pins returns 1. (see #V24CFG)
If <pin>=6 or 7 works as UART pin, the state of the pins is not actual
state because pins are controlled by UART driver
For LE910C1-EUX/SAX/SVX and LE910Cx-WWX product:
- Not support CTS/RTS/RXD/TXD/DTR pins.
- Not support GPIO Kernel mode.
AT#V24?
Read command returns actual state for all the pins (either output and
input) in the format:
#V24: <pin1>,<state1>[<CR><LF>
#V24: <pin2>,<state2>[...]]
AT#V24=?
Test command returns the supported values of parameters <pin> and
<state>.