LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1587 of 1904 2022-03-04
the <en> value is considered only at the very first connection to M2M
Service (AT#DWCONN=1) after a device power on or reboot
feature 0 (Remote AT commands) has no option
AT#DWEN?
Read command returns the current settings for each feature in the format:
#DWEN: <feat>,<en>,<option1>,<option2>,<option3>,<option4>,<option5>
AT#DWEN=?
Test command reports the supported range of values for parameters <feat> and
<en> and the maximum length of <optionX> (where X=1,..,5) parameters.
To Next Page
Loading...
