Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1589 of 1904 2022-03-04
Not Subject to NDA
there is not a LwM2M client mapped
on:
1: Telit client, bit mask 00000001
2: Verizon client, bit mask 00000010
4: AT&T client, bit mask 00000100
8: DOCOMO client, bit mask 00001000
<agentMask>= 0 is not allowed since it
is useless: it means that the
skipping/not skipping required
operation should not affect any
clients.
Giving the command without
<agentMask> parameter will affect all
LwM2M clients.
Value:
1÷FF
:
bit mask length
<reboot>
integer
1
enables or disables the reboot
possibility after the command setting.
Values:
0
:
Reboot is disabled
1
:
Reboot as part of issuing the command (Default)
If the command is used to change the current agents skip settings,
in case of <reboot> parameter missing or set to 1, the module is
rebooted.
No reboot will be triggered if the command is not changing the
current behavior.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English