LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1220 of 1904 2022-03-04
It takes effect on successive GPRS context activation attempt through
#SGACT command in the following manner.
While waiting for AT#SGACT=<cid>,1 response (up to 150 s) is possible to
abort attempt by sending a byte and get back AT interface control(NO
CARRIER indication).
If we receive delayed CTXT ACTIVATION ACCEPT after abort, network will
be automatically informed of our aborted attempt through relative
protocol messages (SM STATUS) and will also close on its side.
Otherwise, if no ACCEPT is received after abort, network will be informed
later of our PDP state through other protocol messages (routing area
update for instance).
the command is not effective while the context is already open.
AT#SGACTCFGEXT?
Read command reports the state of all the five contexts, in the format:
#SGACTCFGEXT: <cid1>,< abortAttemptEnable1 >,0,0,0<CR><LF>
...
#SGACTCFGEXT: <cid max>,< abortAttemptEnable5 >,0,0,0<CR><LF>
Additional info:
To Next Page
Loading...
