Telit Wireless Solutions LE910C series - Page 1462

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1462 of 1904 2022-03-04
Not Subject to NDA
If secure socket is not enabled using #SSLEN only test requests
can be made.
if timeout is not set for SSL connection the default timeout value,
set by AT#SSLCFG, is used.
Before sending data through the SSL connection it hasto be
established using #SSLD.
All special characters are sent like a generic byte.
(For instance: 0x08 is simply sent through the socket and don't
behave like a BS, i.e. previous character is not deleted)
AT#SSLSENDEXT=?
Test command returns the range of supported values for parameters
#SSLSENDEXT: (1),(1-1024),(10-5000)