LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1100 of 1904 2022-03-04
In case of enabling ETH without external PHY, this command
return ERROR.
SIM slot 2 should be disabled before executing this command
because ethernet interface is shared with USIM2 port; please refer
to #SIMSELECT and #ENSIM2 command.
If <mode> is set to 2, ETH will auto enable upon re-connection
based on #ETHMODE setting i.e. backhaul connection is
established or DHCP client executed.
If #ETHMODE is set to 1 and <mode> is set to 1, DHCP client is
executed.
If #ETHMODE is set to 0 and <mode> is set to 1, backhaul
connection is established.
AT#ETHEN?
Read command returns the ETH state and session state.
Additional info:
#ETHEN: <mode>,<state>
OK
Where:
<mode>
0 - ETH disabled state
1 - ETH enabled state
2 - ETH enable and start backhaul connection or DHCP client
<state> - data connection status
0 - disabled
1 - enabled
To Next Page
Loading...
