Telit Wireless Solutions LE910C series - Page 74

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 74 of 1904 2022-03-04
Not Subject to NDA
AT#ACAL?
Read command reports the current automatic call function mode in the
format:
#ACAL: <mode>
As a consequence of the introduction of the command #ACALEXT
(Extended Automatic Call), it is possible that the read command returns a
value supported by #ACALEXT but not supported by #ACAL. Due to this
possible situation it is strongly recommended not to use
contemporaneously both commands.
Because of the typing in of the #ACALEXT (Extended Automatic
Call) command, the #ACAL? read command could return a value
supported by #ACALEXT and not by #ACAL set command.
Therefore, it is strongly recommended to avoid the use of these
two commands at the same time.
AT#ACAL=?
Test command returns the supported range of <mode> parameter values.
•
Assume that #ACALEXT command has been entered. The #ACAL?
read command could return the following parameter value.
AT#ACAL?
#ACAL: 2
OK