Telit Wireless Solutions LE910C series - Page 1028

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1028 of 1904 2022-03-04
Not Subject to NDA
Values:
0
:
DVI slave
1
:
DVI master
2
:
DVI master, clock always on
- #DVI parameters are saved in the extended profile.
- <clockmode> 2 is not saved in the extended profile.
Only <clockmode> 0 or 1 can be saved in the extended profile.
- #DVI parameters are not saved in the extended profile by
LE910Cx ThreadX product.
- On <mode> 0 supported by "DVI master" only.
- When the <clockmode> 2, If change the <clockmode> 2 to
<clockmode> 0 or 1 the device will reboot for clock off.
- #DVICFG and #DVICLK return Error, when <clockmode> 2.
If you want to set the DVI clock in <clockmode> 2, Please set
<clockmode> 2 after set the DVI clock in <clockmode> 0 or 1
- It impact power consumption if using <clockmode> 2.
- The <dviport> parameter have no effect and is included only for
backward compatibility.
- On Active/MT/MO Voice Call return Error.
- <clockmode> 0 and 2 are not supported by LE910Cx ThreadX
product.
- On LE910Cx-WWXD product, the #DVI command will return an
error.
AT#DVI?
Read command reports last setting, in the format:
#DVI: <mode>,<dviport>,<clockmode>.