Telit Wireless Solutions LE910C series - Page 1035

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1035 of 1904 2022-03-04
Not Subject to NDA
<encoder pad>
integer
1
PCM padding enable in encoder
path
Values:
0
:
disable
1
:
enable
<encoder
format>
integer
2
PCM format in encoder path
Values:
0
:
u-Law
1
:
A-Law
2
:
linear
- #DVICFG parameters are saved in the extended profile.
- #DVICFG return Error, when #DVICLK enabled.
- LE910x only supported by first parameter <clock>
- Normal mode (factory default) = 2048KHz with sample rate 8k.
- High speed mode = 4096KHz with sample rate 16k.
- Another parameters (<decoder pad>,<decoder format>,<encoder
pad>,<encoder format>) have no effect and are included only for
backward compatibility.
- The command work only for PCM mode(#DVIEXT=0)
- #DVICFG return Error, when I2S mode(#DVIEXT=1)
- #DVICFG return Error, when clock always on mode(#DVI=1,2,2)
AT#DVICFG=?
Test command returns the supported range of values of parameter
<clock>,<decoder pad>,<decoder format>,<encoder pad>,<encoder
format>.