Telit Wireless Solutions LE910C series - Page 1045

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1045 of 1904 2022-03-04
Not Subject to NDA
When the sending is stopped or an error occurs, an URC is
provided with the following format:
#ASENDEV: <result>
Where:
<result>
0 - file storing done
1 - file storing error
- In case Storing is completed or an error occurs, URC is received.
- Filename has a maximum of 32 characters
- The total size of all audio files must not be over <total size> in
#ASIZE
- The file should be sent using RAW ASCII file transfer. the flow
control is set to hardware and baudrate is set to 115200 bps in the
UART port settings.
- it's not allowed for TE to use two or more serial ports as DATA
service (DUN and asend) simultaneously.
AT#ASEND=?
Test command returns the OK result code.
After the CONNECT, an audio file has to be sent to serial port
•
AT#ASEND="test.pcm",159182
CONNECT