#ACDBEXT is only supported in LE910Cx Linux, Not supported in
LE910Cx ThreadX
In <mode> = 0
After command line terminated with <CR>, We see the
intermediate result code CONNECT.
After this prompt, the file type must be in binary format.
If data successfully sent, then the response is OK.
If data sending fails for some reason, an error code reported.
#ACDBEXT cannot store acdb file to <slot>=0.
<slot>=0 is only for #ACDB, #ACDB can store acdb file to <slot>=0.
In <mode> = 1
Command returns the current <size> of the <category> file.
#ACDBEXT: <size>
In <mode> = 2
Command select the acdb file of <slot> to be loaded into the
module.
Manual reboot is required after changing.
The setting is saved in system.
7 acdb files are 1 set, and it works only when there are 7 files in the
<slot>.
If there are no 7 acdb files in the <slot>, an error is returned.
To Next Page
Loading...
Need help?
General
