Telit Wireless Solutions LE910C series - Page 1082

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1082 of 1904 2022-03-04
Not Subject to NDA
When the command is set with <mode>=2, it could take more time
than the <delay> value due to booting time.
AT#ENHRST?
Read command reports the current parameter settings in the following
format:
#EHNRST: <mode>[,<delay>,<remainTime>]
Additional info:
Read command parameter for <mode> =1 or 2.
Name
Type
Default
Description
<remainTime>
integer
-
time remaining before next
reset
AT#ENHRST=?
Test command reports supported range of values for parameters <mode>
and <delay>.