Telit Wireless Solutions LE910C series - Page 1086

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1086 of 1904 2022-03-04
Not Subject to NDA
1
:
GPIO and serial pins are set in input
with pull down
<DTRWakeUpEn>
integer
0
select the DTR
behavior
Values:
0
:
DTR has no effect on module turned
OFF by #SYSHALT
1
:
DTR transition from low to high
turns on again the module turned off
by #SYSHALT command
<RebootEn>
integer
1
select how the
module exits
SYSHALT
Values:
0
:
module exits from SYSHALT and
stays in detached mode like CFUN=4
status. To restore normal behavior,
the user shall set CFUN=1
1
:
module exits from SYSHALT
performing a total reboot
The parameters are not settable.
AT#SYSHALT=?
Test command reports the range for the parameters <GPIORestore>,
<DTRWakeUpEn> and <RebootEn>.