Telit Wireless Solutions LE910C series - Page 1126

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1126 of 1904 2022-03-04
Not Subject to NDA
therefore it must be disabled by setting <mode>= 5 (status led
disabled).
AT#SLED?
Read command returns the STAT_LED GPIO current setting, in the format:
#SLED: <mode>,<onDuration>,<offDuration>
AT#SLED=?
Test command returns the range of available values for parameters
<mode>, <onDuration> and <offDuration>.
The setting is saved using the #SLEDSAV command.