Telit Wireless Solutions LE910C series - Page 1138

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1138 of 1904 2022-03-04
Not Subject to NDA
<registerId>
hex
N/A
register to write data to
Value:
0÷FF
:
value must be written in hexadecimal form
without 0x
<len>
integer
N/A
number of data to send
Value:
1÷254
:
number of data to send
Additional info:
After entering the command, the module returns the prompt ">"
and waits for the data to send. To complete the operation, send Ctrl-
Z char (0x1A hex); to exit without writing the message send ESC
char (0x1B hex). Data must be written in hexadecimal form.
If data are successfully sent, the response is OK, otherwise an error
code is reported.
AT#I2CWR=?
Test command returns the range of available values for parameters
<sdaPin>, <sclPin>, <deviceId>, <registerId>, <len>.