Telit Wireless Solutions LE910C series - Page 1147

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1147 of 1904 2022-03-04
Not Subject to NDA
Manual reboot is required after changing.
All configurations are stored on module and applied after next
power cycle.
When SPI is enabled through #SPIEN=1, this operation can be
worked.
The first <CS> value is always 0 because it is dedicated SPI_CS pin
(See "Hardware User Guide section 3.1")
It has highest priority than other functions when SPI configuration
enabled and GPIO is used as SPI operation. Customer should not
use GPIO for other function.
AT#SPICFG?
Read command returns the current settings of #SPICFG.
#SPICFG: <ID>,<CS>,<interrupt>,<slave_ready_GPIO><CR><LF>
#SPICFG: <ID>,<CS>,<interrupt>,<slave_ready_GPIO><CR><LF>
#SPICFG: <ID>,<CS>,<interrupt>,<slave_ready_GPIO><CR><LF>
AT#SPICFG=?
Test command returns the range of supported values.