Telit Wireless Solutions LE910C series - Page 1167

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1167 of 1904 2022-03-04
Not Subject to NDA
to Mid CH by default).
Refer to Note 1.
"SETLTEBW [bw]"
:
sets the bandwidth for
LTE. (Before "SETLTEBW"
SET command, you have to
set the "SETLTEBAND"
command.)
“CH [chan]"
:
sets the channel. (Before
"CH” SET command, you
have to set the
"SET<tech>BAND"
Command).
"SETCHREGION [ch_reg_idx]"
:
tunes the RF to lowest (0) /
middle (1) / highest (2)
channel in selected band.
“GETCH"
:
returns current channel.
"TCH"
:
starts the non-stop
module transmission. (not
while RXON active)
"PL [pl_val]"
:
Refer to Note 2.
"TXPDM [txpdm_val]"
:
Refer to Note 2.
"TXGAIN [txgain_val]"
:
Refer to Note 2.
"TXBURST [txburst_val]"
:
Refer to Note 2.
"RXON"
:
RX chain enable. (not while
TCH active)
"LNA [lna_gain]"
:
sets the LNA Gain for GSM
/ WCDMA. Refer to Note 3.
"EXP [expected_pwr]"
:
expected RX power for LTE
/ TDSCDMA. Refer to Note
4.