Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1174 of 1904 2022-03-04
Not Subject to NDA
Note 5: The string of the enabled CT command must have the
correct number of parameters supported by the CT command. The
parameter is not case sensitive.
Note 6: BW should set for each LTE band properly as 3GPP
specification. (TS36.101 5.6.1 Channel bandwidths per operating
band)
Note 7: "CH" command should be input as TX channel. It is going to
auto conversion to RX channel.
AT#TESTMODE?
Read command reports the currently selected <command> in the format:
#TESTMODE: <testModeStatus>
Additional info:
Parameter meaning:
Name
Type
Default
Description
<testModeStatus>
integer
0
status
Values:
0
:
module is in Operative Mode
1
:
module is in Test Mode
AT#TESTMODE=?
Test command returns the ERROR result code.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English