LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1206 of 1904 2022-03-04
Network address should be surrounded by quotes ex) "192.168.168.1" and
the value should be in proper format.
Validation of relationship between ip, netmask and gateway is not checked
when you set. it'll be checked when you execute AT#RNDIS command.
Provide a valid device name, otherwise the results could be not right.
If the User set Customer Address only and do not set device name, then
ERROR would be returned.
This command can only configure IPv4.
AT#RNDISC?
Read command returns the last session configuration in the following format:
Additional info:
#RNDISC:
<Did>,<State>,<Current_Address>,<Current_Address_Mask>,<Current_Address_
Gateway>,<Current_Address
_Dns1>,<Current_Address_Dns2>,<Address_Custom
>,<Address_CustomMask
>,<Address_CustomGateway>,<Address_CustomDns1>,
<Address_CustomDns2>, <Device_Name>
...
OK
To Next Page
Loading...
Need help?
General
