Telit Wireless Solutions LE910C series - Page 1226

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1226 of 1904 2022-03-04
Not Subject to NDA
<cid>
integer
N/A
specifies a particular PDP
context definition (see
+CGDCONT command). If no
<cid> specified, the addresses
for all defined contexts are
returned.
Value:
1÷5
:
supported range
<PDP_addr>
string
-
identifies the terminal in an
address space applicable to the
PDP. The address may be static
or dynamic. For a static address,
it will be the one set by the
+CGDCONT command when the
context was defined. For a
dynamic address it will be the
one assigned during the last
PDP context activation that used
the context definition referred to
by <cid>;<PDP_addr> is omitted
if none is available
AT#CGPADDR=?
Test command returns a list of defined <cid>s.