Telit Wireless Solutions LE910C series - Page 1303

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1303 of 1904 2022-03-04
Not Subject to NDA
Additional info:
If <UDPInfo> is set to 1 (AT#SRECV=<connId>,<maxBytes>,1), the
command returns a message having the following format:
#SRECV: <remoteIP>,<remotePort><connId>,<recData>,<dataLeft>
Name
Type
Default
Description
<remoteIP>
string
-
remote ip address
<remotePort>
string
-
remote port address
<recData>
integer
-
received data
<dataLeft>
integer
-
remaining bytes in the
datagram.
Issuing #SRECV when there is no buffered data raises an error.
AT#SRECV=?
Test command returns the range of supported values for parameters
<connId> <maxByte> and <UDPInfo>.