LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1438 of 1904 2022-03-04
#SSLRECV: NumByteRead
...(Data read)...
OK
If no data are received, the device responds:
#SSLRECV: 0
TIMEOUT
OK
If the remote host closes the connection, the device responds:
#SSLRECV: 0
DISCONNECTED
OK
If secure socket is not enabled using AT#SSLEN, only test requests
can be made.
If timeout is not set for SSL connection, the default timeout value,
set through AT#SSLCFG, is used.
Before receiving data from the SSL connection, it has to be
established using AT#SSLD.
To Next Page
Loading...
